Ramiaudio CDM510 Manuel Utilisateur page 34

[ SNMP configuration.
Do not forget to save your changes by
clicking on the "save config" button.
MIB II system group:
SysContact: The contact person for this managed device.
,
SysName: An administratively-assigned name for this managed device.
,
SysLocation: Location of the unit.
,
RAMI
WEB INTERFACE - next -
user-defined settings in the standard SNMP header.
SNMP Access:
if you want the SNMP agent to respond to the
NMS/SNMP supervisor with different community
names. If less than three communities are riquired,
leave the additional fields blank do disable them.
Doawnload
SNMP trap destination:
and B for sending SNMP traps.
Type: specifies if the trap use
,
format.
Number of Retries:
,
times to resend an inform request
Timeout(sec):
,
for an acknowledgment before resending
Community:
,
trap being sent.
IP adress: destiation adress where the SNMP trap will
,
be sent.
Enable: Enables transmission of SNMP traps to this
,
destination.
34
configure multiple community names
CDM510 MIB file
define target destinations A
V2c
inform or V2c
specifies a maximum number of
specifies a number of seconds to wait
textual name of the group for SNMP
CDM510