Spark Plug Maintenance; Labels; Troubleshooting - Texas LX450TG Manuel De L'utilisateur

3. Wash the black foam element on the right side in warm soapy water.
4. Press the water out of the foam element and let it dry. Put a few drops of SAE-30 oil
on the filter to moisten it lightly with oil. Carefully squeeze out any surplus oil.
Remount the element.
5. Check that all parts are fitted correctly and the cover closed as shown in the picture.

Spark plug maintenance

 Remove the spark plug cap.
 Brush away any dirt and deposit from the spark plug.
 Loosen the spark plug using a spark plug socket.
 Check the insulation is intact.
 Clean the spark plug using a wire brush.
 Measure the electrode gap 0.7–0.8 mm.. Avoid damaging the electrode.
 If it is damaged, replace it with a new one.
 Refit the spark plug.
 Refit the spark plug cap.
Storage
If the machine is likely to be stored unused for prolonged periods, follow the instructions
below. This will ensure longer machine lifetime.
Use a garden hose to wash off soil and dirt. Remove any grass, etc. from the rotor shaft. The
chassis number should only be cleaned with a damp cloth to avoid unnecessary wear. Avoid
using a high-pressure washer during cleaning.
Wipe the tiller with a damp cloth so that all surfaces are clean. Wipe the surfaces down with
an oily cloth to prevent rust.
Always store the machine in a dry, clean location.

Labels

See description fig 19.

Troubleshooting

The motor will not start
1. Check the fuel control is set correctly.
2. Check the spark plug.
3. Check there is fresh gas in the tank.
4. See separate motor instructions for further troubleshooting.
The motor is not running smoothly
1. Ensure the throttle control is not set to max.
2. Check there is fresh gas in the tank.
The blades will not rotate
1. Check for stones lodged between the blades.
Release any stones by removing the blades.
2. Check the cables are in good working order and fitted correctly.
3. Check the belt is in good working order and fitted correctly.
4. Ensure the belt tensioner is adjusted correctly.
15