Lamp Replacement - steel K Manuel D'utilisation

Lamp replacement

Make sure the appliance is disconnected from the
mains power supply.
Light bulbs with different shapes and power
ratings from the original may seriously damage the
light compartment.
• Remove, by levering with a screwdriver, the support
ring "A" for the cover glass.
• Remove the cover glass "B" to access the light
compartment.
• Replace the lamp with the same type (halogen max
20 W - 12 Volt, G4 fitting).
• Replace the glass cover "B" and fasten it using the
special ring "A".
Model with "Square halogen light":
• Completely open the panel to a 90° angle (see figure)
by pressing PUSH.
• Replace the lamp with the same type (halogen max
20 W - 12 Volt, G4 fitting).
• Close the panel correctly.
Model with LED spotlight
In this case the hood is equipped with high efficiency, low
power LED spotlights with extremely high durability
under normal use conditions.
Special maintenance 15
B
A