Operation; Electronic Control Panel; On/Off Button; Increase Button - steel K Manuel D'utilisation

12 Use

Operation

Electronic control panel

The hood has three different suction speeds plus one for

intensive operation.

On/off button

Press this button to start or stop suction.
The hood will operate at the speed selected before last
switching off.

Increase button

Press this button to go to the next suction speed.

Decrease button

Press this button to return to the previous suction speed.
1
Speeds 1, 2 and 3 can be seen by the number of
lit buttons, not including the light and timed switch-
off buttons.
2 3
Intensive operation
On pressing the increase button three times, the hood
enters intensive operation mode (the button flashes).
Intensive operation is timed and the motor returns
rd
automatically to the 3 speed after about 15 minutes.

Timed switch-off and filter saturation alarm

Press this button to automatically switch off the hood
after 15 minutes of operation. The button will flash red
until the suction motor switches off.
After about 30 hours of operation a warning light
automatically appears to indicate the metallic filters
should be cleaned (the button is lit with a steady red light
even when the motor is off). Clean the metallic filters as
described in section "Metal grease-trapping filters" on
page 14.
To deactivate the warning light, hold the button down for
a few seconds.

Light button

Press this button to switch the lights on and off.