Removing The Chimney From The Hood (Gk And Ak Hoods Only); Removing The Metallic Filters; Removing The Chimney - steel K Manuel D'utilisation

8 Installation
Removing the chimney from the hood
(GK and AK hoods only)
In type "K" and "AKL" hoods, the chimney is
packed next to the hood; in type "GK" hoods, the
chimney is secured in the interior compartment
and turned 90° (fig. 1); in type "AK" hoods, the
chimney is secured in the interior compartment, in
a central position in front of the suction motor
(fig. 2).

Removing the metallic filters

• Lower the splines "A1" and pull the filters "A"
downwards.
• Keeping the filters tilted down, remove them by pulling
out.
The connector "B" is now accessible. In type "GK"
and "AK" hoods (figure 2), the connector "B"
should be released from the suction motor to allow
the removal of the plastic reducer "E".

Removing the chimney

• Unscrew the screws "C" to free the chimney "D".
• Take out the chimney "D", complete with extension,
from the hood compartment.
C
D
C
D
C
12 cm
E
Fig.1
A
A1
Fig.2
B
C
A