Accessories On Request; Coloured Edge (Type Gk Hoods Only); Active Charcoal Filters; Models With Square Filter (Type K And Akl Hoods) - steel K Manuel D'utilisation

16 Accessories

Accessories on request

Make sure the appliance is disconnected from the
mains power supply.

Coloured edge (type GK hoods only)

Front moulding in painted steel available in a variety of
colours.
• Remove the metallic filters "A".
• Unscrew the ten screws "B" from inside the hood.
• Remove the standard edge.
• Replace with the new edge "C", making sure the control
panel "D" is correctly fitted in the edge frame.
• Tighten the ten screws "B".
• Reposition the metallic filters "A".
B
D
C
A

Active charcoal filters

Two types of active charcoal filters are available,
depending on the hood model.

Models with square filter (type K and AKL hoods)

• Remove the metallic filters.
• Place the nut "F" above the filter housing slot.
• Position the filter "B" in the housing and fasten it by
screwing knob "C" in nut "F".
• Reposition the metallic filters.
B
C

Models with round filter (type GK and AK hoods)

• Remove the metallic filters.
• Rest the filters on the motor (one on each side), taking
care to place the pins close to hooks "E" on the motor.
• Turn the filters clockwise until properly hooked on.
• Reposition the metallic filters.
Contact your distributor to order new active
charcoal filters.
F
F
E
E
E