Electrical Connections; Test - steel K Manuel D'utilisation

Electrical connections

The connections must be performed in
compliance with the legal standards in force.
Check that the relief valve and the electrical
system are able to support the load of the
appliance.
The equipment is not fitted with plugs.
The yellow/green earth wire must not be
disconnected by the switch.
The technical specifications of the appliance are
shown on the rating plate located inside the range
hood. Make sure the mains voltage corresponds
to the values on the rating plate.
Use plugs conforming to current electrical standards,
taking into account that:
• the yellow-green wire must be used for the earth;
• the blue wire must be used for the neutral;
• the brown wire must be used for the phase; the cable
must not come into contact with hot parts (over 75° C);
• fit a plug that is suitable for the load to the power cable,
and connect it to a suitable power outlet.
Before plugging in the appliance, check that:
• the power voltage corresponds to that indicated on the
specification plate;
• the earth connection is correct and operational;
• the power supply system has an effective earth
connection according to current legislation;
• the socket or the omnipolar switch used are within easy
reach when the appliance is installed.

Test

Check:
• that the duct and external outlet are not blocked;
• the metallic and active charcoal filters (if fitted) are
positioned correctly. Refer to section "Active charcoal
filters" on p. 16.
Connect the hood to the electric supply, switch on the
motor as described in section "Operation" on p. 12 and
check:
• the correct operation and suction capacity at all
selectable speeds;
• the correct operation of the lights.
Installation 11