Replacement Of Lamps; Cleaning; If You Encounter A Problem; Coloured Edge (Optional) - steel Genesi Manuel D'utilisation

Instructions for the user
6.4

Replacement of lamps

Always replace the lamps with lamps which have the same electrical characteristics. Before
replacing the lamps, make sure that they are cold and that power has been completely turned off.
Please follow the sequenze as shown in the specific mounting pictures (page 78).
Reconnect to electricity.
If the lights are not working, check that the lamps are correctly fit.

7. Cleaning

To preserve the hood in good condition, clean this periodically following the advice given as
follows.
Make sure that power has been completely turned off.
The detergent solution recommended is a combination of water and neutral liquid soap.
It is of vital importance that the liquid soap should not contain any grains which could scratch the
surface.
The solution should be applied first onto a soft cloth which is then rubbed over the shell. It is
important to follow the pattern of the satin finish with the cloth.
It is absolutely forbidden to pour liquids directly onto the hood.
The cloth used should not have any buttons, zips, fasteners or anything else which could scratch
the surface.
The use harsh abrasive or granular products, petrol, spirits or similar products which could damage
the surface of the materiall, is severely forbidden.
The manufacturer will not be responsible for any damages either functional or to the
appearance of the hood, caused by cleaning operations carried out using unsuitable
products or unsuitable methods.

8. If you encounter a problem

Disconnect the hood from the mains electricity supply and keep it disconnected for ca 1 minute,
then reconnect.
If the behaviour of the hood seems strange, read the procedure for resetting carbon and grease
filters concerning the kind of control in your hood (see chapter 5. Operating the appliance).
If the lights of the lamps is weak when the hood is in stand-by, then invert the plug.
If the fault persists, contact our Technical Assistance Service.

9. Coloured edge (optional)

Front moulding in painted steel available in a variety of colours.
Mount the "trim kit" as shown in the specific mounting pictures (page 79).
31