Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Before each fault clearance
switch off device
wait until the drum is stationary
pull out main plug
After each fault clearance, put into operation and recheck all security installations.
Fault
Device doesn't start
The device operates with
interruptions
Unusual sounds
Unusual vibrations
Unsatisfactory verticulating
result
Please observe the enclosed terms of guarantee.
26
P
P
Possible cause
no power
Extension cable defect
Main plug, motor or switch defect
Protective motor switch has tripped
Incorrect start-up
Extension cable defect
Internal fault.
ON/OFF button defective.
Drum is blocked
Toothed belt slips
Loose screws, nuts or other fasteners
Cutting blade damaged or dull
Work depths too deep
Lawn too high
Work depth too low
Dull blades
Discharge opening blocked
o
s
s
i
b
l
e
f
a
u
l
t
s
o
s
s
i
b
l
e
f
a
u
l
t
s
Remedy
Check power supply, power socket and fuse
Check extension cable, exchange defect
Have motor or switch checked by an approved
1. Work depth too deep reduce work depth
2. Drum blocked remove the blockage
3. Grass too long mow the grass
Allow the motor to cool down approx. 15
Use the correct start-up procedure.
Check extension cable, exchange defect
Please contact the after sales service.
Please contact the after sales service.
Remove the blockage
Please contact the after sales service.
Tighten all parts; contact customer service if
See "Changing blades"
Set a lower work depth
Mow the lawn before thatching
Set a greater work depth
See "Changing blades"
Empty the grass catching bag and remove the
G
u
a
r
a
n
t
e
e
G
u
a
r
a
n
t
e
e
protection
cable immediately
electrician or replaced by original spare parts
minutes before continuing to work
cable immediately
the noises continue to occur.
blockage
Publicité
Chapitres
Table des Matières
