Guarantee; Possible Faults - ATIKA RMC 40-510 Notice Originale

Please observe the enclosed terms of guarantee.
Before each fault clearance
 switch off device
 Wait until the cutting blade has come to a stop
 Pull off the safety key and remove the batteries

After each fault clearance, put into operation and recheck all security installations.
Fault
Machine does not start after
switching on
Machine does not work with
full performance
The device operates with
interruptions
Unusual vibrations or noises  Cutting blade damaged or dull
Unsatisfactory mowing
results
Cutting time with fully
charged battery too short
Unit shuts off by itself
Motor is running, blades
stopped

In case of further faults or inquiries please contact your local dealer.
20

Possible faults

Possible cause
 Safety key not inserted
 Wrong starting sequence
 Lithium ion battery run down
 Lithium-ion battery not engaged correctly
 Lithium ion battery too hot / cold
 Grass clogs the mower housing
 Lithium ion battery defective
 Safety button or switch handle defective
 Internal fault
 Lithium ion battery run down
 Lithium ion battery defective
 Internal fault.
 Safety button or switch handle defective
 Device overloaded as grass too high
 Loose screws, nuts or other fasteners
 Cutting height set too low
 Dull blades
 Discharge opening blocked
 Collecting bag is full
 Rechargeable battery is low
 Battery service life exhausted
 Grass too high, dense or cutting height set
too low
 Lithium ion battery too hot (45 °C)
 Battery charge too low
 Internal fault.

Guarantee

Remedy
 Insert the safety key between the batteries
 See chapter on "Startup"
 Charge the lithium ion battery
 Insert the lithium-ion battery correctly
 Allow lithium ion battery to cool / warm up
 Pull off the safety key and clean the housing
 Please contact the after sales service.
 Charge the lithium ion battery
 Please contact the after sales service.
 Please contact the after sales service.
 Adjust a larger cutting height
 See "Blade replacement"
 Tighten all parts; contact customer service if
 Adjust a larger cutting height
 See "Changing blades"
 Empty the grass catching bag and remove the
 Empty the collecting bag
 Charging the rechargeable battery
 Replace the rechargeable battery
 Adjust a larger cutting height, walk more slowly
 Allow lithium ion battery to cool
 Li-Ionen Akku laden
 Please contact the after sales service.
the noises continue to occur.
blockage
and / or mow more often