Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
A
s
A
s
H
a
n
d
l
e
h
o
o
p
H
a
n
d
l
e
h
o
o
p
/
Turn the hoop holders (8/9) and slide the screw
heads in the guide slots of the holders (11/12).
Firmly tighten the star grips (6).
Secure the connecting bars (5) to the hoop holders
(8/9). Use the supplied fasteners (2x star grip (6), 2x screw
M6x45 (7)).
Secure the handle hoop (1) to the connecting
/
bars (5). Use the supplied fasteners (2x star grip (6), 2x
screw M6x45 (7)).
Fix the cable using the cable holders (4). Make sure
that the cable has enough free motion.
A
d
j
u
s
t
i
n
g
t
h
e
o
p
e
r
a
t
i
n
g
A
d
j
u
s
t
i
n
g
t
h
e
o
p
e
r
a
t
i
n
g
Loosen the star grips (6) on the hoop holders
/
(8/9).
Turn the handle hoop to your desired position and retighten
the star grips.
Grass catching bag – optional accessory, if applicable
Pull the impact guard (36) up and hold it.
Mount the hook of the grass catching bag (40) to the holder
on the housing (35).
Installing the aerator drum - optional accessory
Before exchanging the drums:
switch off device
wait until the drum is stationary
pull out main plug
Wear protective gloves when exchanging
the drums. Risk of injury!
If the device shall be used as lawn aerator, the scarifier drum
(29) must be exchanged against the aerator drum (31).
Remove the cylinder head screws (34) on the bearing
holder (33) using the supplied installation wrench (42).
Lift the scarifier drum and pull it out.
Push the hexagonal protrusion (a) of the aerator drum into
the drive opening (32).
Remount the bearing holder (33) using the screws (34).
S
S
Mains connection
Compare the voltage given on the machine model plate e.g.
230 V with the mains voltage and connect the machine to the
relevant and properly earthed plug.
s
e
m
b
l
y
s
e
m
b
l
y
h
e
i
g
h
t
h
e
i
g
h
t
t
a
r
t
-
u
p
t
a
r
t
-
u
p
Connect the machine via a circuit breaker switch (residual-
current-operated circuit switch) 30 mA.
Use connecting or extension cables up to a length of 1.5 m
featuring a core cross section of at least 25 mm².
M
o
u
n
t
i
n
g of the extension cable
M
o
u
n
t
i
n
g
Plug the female connector of the extension cable on
the male connector (2) of the switch-connector combination.
Thread the extension cable through the strain relief (3) as a
loop and hang it up.
Make sure that the extension cable has enough free motion.
S
S
w
w
i
i
t
t
c
c
h
h
i
i
n
n
g
g
o
o
n
n
The device is equipped with a safety circuitry preventing
inadvertent switching on.
Make sure before each startup that the safety button
and the switch lever are working properly.
Do not use the unit if it can only be switched on with
the switch lever. Damaged switches must be
repaired or replaced immediately by the customer
service.
Start the device only after you have placed it on a
low-growth lawn area.
Switching on
Tilt the scarifier slightly towards you so that the front
wheel are above the ground.
Push the safety button and keep it depressed.
Next, pull the switch lever toward the handle hoop.
The scarifier starts and the scarifier drum can rotate freely.
Now release the safety button.
Switching off
When you release the switch lever it returns automatically to its
original position.
Motor protection
The motor is equipped with a protective circuit breaker and
switches off automatically in case of overloading. After a
cooling-down break (approx. 15 min), the motor may be
restarted.
Release the switch lever because the device will
otherwise restart immediately after it has cooled down.
Risk of injury!
23
Publicité
Chapitres
Table des Matières
