Transport; Storage; Disposal; Guarantee - ATIKA RMC 40-400 Notice Originale


Remove both clamping plates (17, 18).
 Remove the cutting blade


When installing the new cutting blade, pay attention to
the mounting direction specified by the holders in the
cutting blade.
 Mount the two clamping plates (17, 18) and screw all parts
together with the fastening nut (19). Tighten the nut firmly.
When working on the lawn mower, be careful not to
pinch fingers between moving cutting blades and
stationary parts of the machine.
Cleaning
Clean the device carefully after each use to ensure

faultless function to be maintained.
Wear protective gloves when working on the
cutting blade. Risk of injury!
 Clean the device immediately after finishing the work.
 Empty and clean the grass catching bag if necessary.
 Clean the underside of the unit and the cutting blade.
 Clean the housing, especially the vent slots, from grass and
dirt stuck to it.
 Remove the dirt with a cloth or brush.
 Do not clean the machine with running water or high-
pressure cleaners.
 Do not use solvents for the synthetic parts (petrol, alcohol,
etc.) as these can damage the synthetic parts.

For information on maintenance and cleaning of the
battery and the charger, please refer to the respective
operating Instructions.

Transport

Before each transport, switch off the unit,
remove the safety key and remove the battery
(batteries) to prevent unintentional start-up.
Even when the motor is switched off, the cutting blade can be
damaged during transport, e.g. over hard ground. Therefore,
set the cutting height to the highest position for transport.

For information on transport of the battery and the
charger, please refer to the respective operating
Instructions.

Storage

Before each storage, remove the safety key
and remove the batteries to prevent them
from starting unintentionally.
 Allow the motor to cool down before storing the machine.
 Store unused equipment in a dry, locked place out of the
reach of children.
 Before a longer storage observe the following in order to
prolongate the service life of the machine and to guarantee
a smooth running operation:
thoroughly clean the machine
-
-
Treat metal parts after each use against corrosion using
an environmentally friendly biologically degradable
spray oil.

Never use any grease!

To facilitate space-saving storage of the device, you can
fold down the handle hoop. Loosen the star grip screws
(6) for this purpose until the handle hoop (2) can be
folded.

For information on storage of the battery and the charger,
please refer to the respective operating Instructions.

Disposal

Dispose of the lawn mower, battery, charger, accessories
and packaging in an environmentally friendly manner.
For EU countries only.
Electrical devices do not go into the domestic
rubbish.
According to the European Directive 2012/19/EU on
electrical and electronic scrap, electrical devices that
are no longer serviceable must be separately
collected and brought to a facility for an
environmentally compatible recycling.

For information on disposal of the battery and charger,
please refer to the respective operating Instructions.

Guarantee

Please observe the enclosed terms of guarantee.
19