Dimensional Information - Tuthill Fill-Rite FR1200G Série Mode D'emploi

Troubleshooting (cont'd)
Motor stalls /
fuse blows or
thermal
protector trips
repeatedly.
Motor
overheats.
Motor
Inoperative.
Fluid leakage.
Pump hums but
will not operate.
Bold text indicates service that cannot be performed by the owner; pump must be returned to the point of purchase for
this type of service.
* Repairs marked with an asterisk (*) will require Repair Kit KIT120RG Kit includes replacement rotor and new vanes,
as well as a number of other important seals and components to complete the repair. Details of this kit are on page 18.
WARNING! Disconnect electrical power and relieve any pressure in the lines
prior to servicing this pump! Failure to do so can result in damage to the
equipment and personal injury or death!

Dimensional Information

1. Bypass valve sticking.
2. Low voltage.
3. Excessive rotor or vane
wear.
4. Debris in pump cavity.
1. Pumping high viscosity
fluids.
2. Clogged screen.
3. Restricted suction pipe.
4. Motor failure.
5. Pump rotor lock-up.
1. No power
2. Switch failure.
3. Motor failure.
4. Thermal protector
failure.
5. Incorrect/loose wiring.
1. Bad o-ring gasket.
2. Dirty shaft seal.
3. Bad shaft seal.
4. Incompatible fluid.
5. Loose fasteners.
1. Motor failure.
2. Broken rotor key.
Remove and inspect valve; must
move freely & be free of debris.
Check incoming line voltage while
pump is running.
Check rotor & vanes for excessive
wear or damage.*
Clean debris from pump cavity.
These fluids can only be pumped
for short periods of time (less than
30 minutes duty cycle).
Remove and clean screen.
Remove and clean pipe.
Return to place of purchase.
Clean and check pump rotor and
*
vanes.
Check incoming power.
Replace switch (KIT120SW).
Return to place of purchase.
Return to place of purchase.
Check wiring.
Check all o-ring gaskets.
Clean seal & seal cavity.
Replace seal.
Refer wetted parts list to fluid
manufacturer.
Tighten fasteners.
Return to place of purchase.
Remove all debris & replace key.
14