Topcom Butler Outdoor 2010 TWIN Manuel D'utilisateur page 19

Butler Outdoor 2010 - Twin - Triple
4.22 Switching the charge tone on/off
You can set the handset so that a beep is generated whenever you
place the handset inside the base or charger.
To turn this on/off you have to follow above procedure (see "4.19
Switching the keypad beep on/off") but select 'CHARGE TONE'
instead of 'KEY BEEP'.
4.23 Changing the handset name
Proceed as follows to change the handset name that is shown in
the display in standby mode:
1. Press twice.
17
4 15
2. Press or repeatedly, select 'HANDSET NAME'.
3. Press to confirm.
17
4. Press ESC 3 repeatedly to delete the letters in succession
and use the alphanumeric keypad to enter a new name.
5. Press to set the new handset name.
17
4.24 Auto talk
When the handset is in the base station and receives an incoming
call, the call is answered automatically when the handset is
removed from the base station or charger. You can choose
whether or not this function should be activated.
1. Press twice.
17
4 15
2. Press or repeatedly, select 'AUTO ANSWER'.
3. Press to confirm.
17
4. Select 'ON' or 'OFF' and press
4.25 Auto hang-up
When the handset is in communication, the call is ended when
handset is placed inside the base station or charger when auto
hang-up is on. If auto hang-up is off during talk mode, the handset
will switch to handsfree speaker when placed inside base or
charger. You can choose whether or not this function should be
activated.
1. Press
2. Press
3. Press
4. Select 'ON' or 'OFF' and press
4.26 Voicemail dial key number
By pressing the voicemail key
pre-programmed number. You can use this to dial for example
your voice mailbox.
To program this number:
1. Press
2. Press
3. Press
4. Enter the voicemail number from your provider and press
5
5.1
to confirm.
17
1. Press
2. Press
3. Press
twice.
17
4 15
or repeatedly, select 'AUTO HANGUP'.
to confirm.
17
for 3 seconds the phone dials the
twice.
17
4 or 15 repeatedly, select 'VOICEMAIL'.
to confirm.
17
to confirm.
17
Time and alarm functions
Setting the date and time
If caller ID (CLIP) is activated on your telephone line and
the provider transmits the date and time, the clock is set
automatically when an incoming call is received. Unless
you turn this function off (see below "5.3 Auto clock
adjust"). When you have set the date/time of a handset,
all handsets of that base station will adopt these settings.
17 .
4 15
or repeatedly, select 'CLOCK & ALARM'.
to confirm.
17
Time and alarm functions
to confirm.
17
19