Encoding - Abus TVHD80000 Manuel Utilisateur

Recording

At Copy you can take on this setting for other days or
the whole week.
6. Finalize your settings in the record screen with Apply
and then OK.

Encoding

TAB Record
The following setting possibilities are available in this
sub-menu:
Camera
Camera to be set
displays the incoming, and thus the
Input Resolu-
maximum, resolution of the camera
tions
Encoding Pa-
Stream 1: Properties for continuous
rameters recording
Stream 2: Properties for event re-
cording (Alarm / motion)
Stream 3: Properties for network
transmission
Stream Type
Video
Video & Audio
Resolution
1920x1080, 1280x720,
4CIF(704x576), CIF(352x288),
Bitrate Type
In general, the higher the bit rate, the
more storage space is required.
Variable:
Static image – low bit rate; dynamic
image – high bit rate
Constant:
Bit rate remains constant (at maxi-
mum bit rate)
Video Quality
There are various quality levels:
+: Low quality
++++++: High quality
Frame Rate
Number of images saved per second.
The maximum number is dependent
on the set resolution.
Select between free entry of bit rate /
Max. Bitrate-
list of standardized bit rates
Mode
Max. Bitrate
Defines the maximum bit rate for the
(Kbps) "Constant" bit rate type
1. Select the camera.
2. Select the stream where the specifications should be
defined:

Stream 1 (Continuous)

Stream 2 (Event)

Stream 3 (Network)
3. Define the recording parameters for the correspond-
ing stream (see table).
4. Under More, select the period for the pre-alarm,
post-alarm etc.
5. Click on Copy to take on these settings for other
cameras.
For detailed settings click on More.
Pre-record
Recording period before an alarm
(in seconds)
Post-record
Recording period after an alarm
(in seconds)
Expired Time (day)
Period (in days) after which the
recording is deleted automatically
at 00:00. The event remains in the
log file.
0: Recordings are not deleted
automatically
Redundand Re-
Choose wheter the data shall be
cord/... overwritten when HDD is full
Record Audio
Audio record yes/no
Confirm the settings by clicking on Apply and leave the
menu with OK.
98