Alarm Output - Abus TVHD80000 Manuel Utilisateur

TAB Handling
Define the response in the case of an alarm:
Parameter Setting
Full Screen
A message appears on the monitor.
Monitoring
Audible Warning The device emits a repeating tone.
Notify Surveil- Sends an alarm signal to a PC with
lance Center ABUS CMS software. The software
must be enabled and the recorder
set to surveillance mode on the PC.
Send E-Mail An e-mail is sent to a specific e-mail
address (see page 106).
Upload captured
Saves the camera image on a previ-
pictures to FTP
ously configured FTP server, see p.
106 (only for motion detection)
Trigger Alarm see also page 108
Output
Confirm the settings by clicking Apply and leave the
menu with OK.
Note
To record with the aid of an alarm, you must set
up the schedule under Recording (see p. 97).
109
TAB PTZ Linking
Currently no functioning.

Alarm output

1. Select an alarm output to be configured in the
drop-down menu under "Alarm Output No.".
2. Assign any name to the alarm output in "Alarm
Name".
3. In "Dwell Time", select how long the alarm is trig-
gered for.
4. In "Handling", select the schedule for the alarm
output.
5. Click Copy to apply these settings for other alarm
outputs.
6. Confirm the settings by clicking Apply and leave
the menu with OK.
Configuration