Network Settings; Hdd Management - Abus TVHD80000 Manuel Utilisateur

Setup wizard

Network Settings

Note
To check whether DHCP can be selected (or if
you have to set the IP address and other settings
manually), consult your network administrator.
1. DHCP activated: If DHCP is set up in the network
router, then tick the DHCP box. All network settings
are then made automatically.
2. DHCP not activated: Enter the data manually (IPv4
address, IPv4 subnet mask and IPv4default gateway
= IPv4 address of the router). You can also option-
ally enter the address of the DNS server that you
need for sending the E-mail.
A typical address specification is as follows:

IPv4 address:

IPv4 Subnet mask:

IPv4 Default gateway:

Preferred DNS server:
Note
If you have selected the "multi-address" mode,
then you must configure both network connec-
tions. For this, change the LAN output at "select
NIC".
Note
When the device is accessed remotely via the
internet, it should be given a fixed network ad-
dress.
Because this device has two network connections, there
are setting possibilities for the parallel and the separate
use of the connections:

HDD Management

192.168.0.50
255.255.255.0
192.168.0.1
192.168.0.1
1.
2.
3.
A LAN connection is selected for the
Net Fault-
data transfer (select "NIC"). The other
tolerance
connection is in a type of standby
mode. If ,for whatever reason, data
transfer can no longer be guaranteed
(e.g. broken network card, defective
cable...), change the device to the
other interface and use this for data
transfer.
When this mode is selected, both net-
Load
work cards/network connections work
Balance
together in order to get a broader
band width.
When selecting this mode, configure
Multi-
the network data separately for each
adresse
connection. In this way it is possible to
integrate the device into two different
networks, so that the network load is
reduced.
Note
Further information on the network settings can
be found on page 41.
To set up a new hard disc, activate the "Check box"
with a left click and then click on Init.
Warning
All data on the drive is deleted!
Confirm the prompt by pressing OK. The HDD is
then set up for operation. The progress is displayed
on the status bar.
Exit the setting by pressing Next.
82