Fitting & Removing The Parts; The Dual Blade; Control Switches - Cuisinart MINI PREP PRO ECH4PE Manuel D'utilisation

A. FITTING & REMOVING THE PARTS
1. Place the housing base on a flat, dry, stable surface.
2. Place the work bowl over the motor base with the handle facing forward and positioned slightly to
the left of the control panel (the bowl will slot onto the base).
3. Turn the bowl in an anticlockwise direction until it locks into position on the housing base.
N.B. The work bowl must be securely locked into position. The bowl will be in the correct position
once the handle is central to the control panel.
4. Carefully lift the blade assembly, holding the central plastic stem and place over the motor spindle.
Push the blade down until it clicks into place. The lower part of the blade assembly should almost
touch the bottom of the work bowl.
N.B. Always hold the blade assembly from the plastic stem.Never touch the blade as it is very sharp.
N.B. Never place the blade on the motor shaft until the work bowl is locked into place.
N.B. Always insert the blade in the work bowl before adding ingredients.
5. Add the food you wish to process.
6. Place the lid on the work bowl with the small tab to the left of the work bowl handle. Turn the cover
anticlockwise (toward handle) to securely lock.
N.B. The work bowl and lid must be tightly locked into the interlock device.Once securely fitted a
loud click is heard. If both the work bowl and the lid are not fitted securely the processor may work
intermittently.
7. To remove the lid, hold the housing base with your left hand, securely grip the handle on the top
of the lid and rotate it in a clockwise direction.
N.B. Make sure the motor has completely stopped and the blade has stopped moving before
removing the lid.
ATTENTION: The lid must always be removed before fitting or removing the work bowl from the
base.
8. To remove the blade, gently pull up to disengage blade lock away from the motor spindle holding
the plastic stem.
9. To remove the work bowl, firstly ensure the lid has been removed. Hold the housing base with your
left hand, then hold the work bowl handle with your right hand and turn in a clockwise direction
to unlock and lift away from the housing base.
B. THE DUAL BLADE (see Fig. 1 in the cover)
This appliance processes using a dual blade with a sharp, curved edge (A) for chopping/mixing and
a flat, blunter edge (B) for grinding.
C. CONTROL SWITCHES
To start operation, simply press one of the two switches and hold down for the desired length of time.
Use the 'Chop' speed switch for chopping, puréeing and mixing food with the sharp edge of the
blade.
20