Maintenance; Servicing The Flue System; Servicing The Stove; Inspection And Maintenance Plan - Palazzetti WILMA Notice D'installation

Masquer les pouces Voir aussi pour WILMA:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

7

MAINTENANCE

7.1
MAINTENANCE
The stove may only be maintained by an authorised technical service centre.
Prior to effecting any maintenance operation, adopt the following precautions:
-
Make sure that the stove is completely cold.
-
Make sure that the ashes have gone out completely.
-
Use the personal protective equipment speci ed in Directive 89/391/EEC..
-
Make sure the mains power is off at the master power switch.
-
Ensure that the power supply cannot be restored accidentally. Remove the power plug from the socket.
-
Always use proper tools.
-
Once maintenance or repair activities are completed, reinstall all the protections and reactivate all the safety
devices prior to restarting the system.
7.2

SERVICING THE FLUE SYSTEM

This must be done at least once a year, or every 4 tons of pellets.
If the ue has any horizontal sections, remove any ash and soot before they can block the ue itself.
If it is not kept clean, the stove may experience problems including:
-
poor combustion
-
blackened glass
-
blocked brazier, accumulated ash and pellets
-
ash and excessive encrustations on the heat exchanger, which lower its ef ciency.
7.3

SERVICING THE STOVE

This must be done at least once a year, or whenever the stove itself displays the maintenance required message.
The technician must:
-
thoroughly clean the fumes circuit
-
check the condition and tightness of all seals
-
check the condition and cleanliness of all internal components
-
check the tightness and cleanliness of the connection of the ue to the stove
-
remove all pellet residue remaining in the pellet tank
-
check for pellets and pellet residue in the stove's installation cavity
-
check that the stove is operating properly
-
reset any warnings and alarms.
7.4

INSPECTION AND MAINTENANCE PLAN

Burn pot
Ash bin/Compartment
Glass
Heat exchanger
Ignition heater socket
Flue gas manifold
Door and burn pot gaskets*
Flue*
Fans*
responsibility of the Authorised Service Centre.
(*)
This must be done at least once a year, or every 4 tons of pellets.
(a)
36
INSTALLATION
WHENEVER
WEEKLY
STARTED
X
X
X
X
1 MONTH
1 YEAR
(a)
X
X
X
X
X

Publicité

Table des Matières
loading

Table des Matières