dji Ronin-S Guide De Démarrage Rapide page 7

2. Attach the camera dovetail plate and lens support*.
3. Slide the camera onto the camera mounting base. When a rough back and forth balance is
reached, toggle the lever to the locked position after the safety lock is engaged.
2
3
4. It is recommended to mount the camera using the Top Hotshoe Bracket when mounting the
gimbal on a car or shooting in environments when traveling at high speeds where wind forces
can affect the gimbal stability. The Top Hotshoe Bracket is sold separately. The installation is
shown below.
1
Balancing
1. Balancing the Vertical Tilt
a. Rotate the tilt axis so that the camera lens is pointing up. Hold the tilt axis motor to ensure the
roll axis remains horizontal and check if the camera is top or bottom heavy.
b. Loosen the knob
still without tilting it up or down.
c. Tighten the knob.
* For the best results during setup, use the lens support whenever possible.
1
2
on the tilt motor and adjust the camera balance
1
RONIN-S Quick Start Guide
4
until the camera stays
2
1
2
©
2018 DJI OSMO All Rights Reserved.
5
5