2-Channel Microphone System
These instructions are intended for users without
any specific technical knowledge . Please read
these instructions carefully prior to operating the
unit and keep them for later reference .
All operating elements and connections
described can be found on the fold-out page 3 .
1 Operating Elements and
Connections
1.1 Receiver
1 Receiving antennas
2 On / off switch
1 s), lights up as a power indication
3 Connection indicators, one each for MIC 1
and MIC 2
4 VOLUME controls, one each for MIC 1 and
MIC 2
5 Momentary pushbutton RESET to reset
the radio connection for the first channel
(for service only)
6 Signal output for the mixed signal of both
microphones: 6 .3 mm jack, unbalanced
7 Momentary pushbutton RESET to reset the
radio connection for the second channel
(for service only)
8 Power supply jack for connection of the sup-
plied power supply unit
1.2 Microphone
9 On / off switch
– lights up as a power indication
– flashes if the batteries are low
to switch off, keep it pressed for a while
10 Area of the transmitting antenna;
do not cover during operation!
Rear side with the battery compartment
opened
11 Rotary switch to select the transmission
channel
12 Batteries in the battery compartment
(keep it pressed for approx .
2 Safety Notes
The units (wireless microphones, receiver and
power supply unit) correspond to all relevant
directives of the EU and are therefore marked
with
.
WARNING The power supply unit is supplied
with hazardous mains voltage .
Leave servicing to skilled per-
sonnel only . Inexpert handling
or modification of the unit may
cause an electric shock hazard .
•
The units are suitable for indoor use only . Pro-
tect them against dripping water and splash
water, high air humidity, and heat (admissible
ambient temperature range 0 – 40 °C) .
•
Do not set the receiver into operation, and
immediately disconnect the power supply unit
from the mains socket if
1 . there is visible damage to the units,
2 . a defect might have occurred after a drop
or similar accident,
3 . malfunctions occur .
The units must in any case be repaired by
skilled personnel .
•
For cleaning only use a dry, soft cloth, never
use chemicals or water .
•
No guarantee claims for the units and no
liability for any resulting personal damage or
material damage will be accepted if the units
are used for other purposes than originally
intended, if they are not correctly connected
or operated, or if they are not repaired in an
expert way .
If the units are to be put out of oper-
ation definitively, take them to a local
recycling plant for a disposal which is
not harmful to the environment .
3 Application
The TXS-2402SET is an easy-to-use 2-channel
wireless microphone system consisting of two
hand-held microphones and a receiver . It is suit-
able for versatile applications, e . g . for presenta-
tions, discussions or karaoke . The microphone
signals are digitally transmitted with low inter-
ference on 2 of 16 selectable channels in the
2 .4 GHz range . Two receivers with four micro-
phones can be used at the same time .
7