WOLFF RUMBA Traduction Du Mode D'emploi Original page 11

5.4 Use
Mount discs and brushes as described in Item 4.0.
Put the handle (2) in working position with the big, right
lever (1).
We recommend to position the hand grip in the height of
the users hip.
Lift the handle slightly, to make sure the machine stands
horizontally.
Move the left or right safety lock (3) located onto the grip
inwards.
Switch on the machine with the respective lever (4).
After switching on the machine, the handle will move shortly to
the right.
The direction in which the machine moves, is controlled by lifting
or lowering the grip. The more you lift or lower the grip, the faster
the machine runs to the corresponding direction.
Lifting the grip:
Lowering the grip:
If you feel unsafe or cannot control the machine just release
lever (4). The machine will stop at once.
If you have carried out some training, you will be able to operate
the machine with one hand.
Always remove discs or brushes after work. Remove also the
cleaning tank, if one has been used.
Always disconnect the power cord after work or when leaving
the machine.
Operation with cleaning tank
Assemble the cleaning tank with 2 supports to the handle.
1. Check the set
2. Put the tank a on the lower support
3. Block A by pushing down the upper support
4. Insert C as shown in the picture
5. 1. Insert B in the hole on the handle
2. Insert the ring in the lever
6. Screw the catch on the pushrod
7. Check that the chain B is not under tension
For cleansing the following accessories are necessary:
Cleaning tank
Shampoo brush soft
Polishing brush hard
03/2010
machine runs to the right
machine runs to the left.
#059831
#013521
#013522
Poliermaschine RUMBA (230 V), #013509
Lever (4) can only be actuated, if the handle is not in
vertical position. This is a safety feature! The user
cannot control the machine with vertical handle.
1
2
3
4
5
6
11