Publicité
Les langues disponibles
Les langues disponibles
Connections
1. Before you use this unit, make sure that the AC adapter (23) is of the correct voltage.
2. The unit is supplied with AMP output jacks. The AMP (20) jacks are unbalanced and used to
connect to your amplifier.
3. The MIC L (15) and MIC R (16) inputs accept a ¼" connector.
4. On the rear panel are 2 stereo PHONO/LINE (17, 18) inputs and 1 stereo CD input. The
PHONO/LINE (4) enables you to set the (17) input to PHONO or LINE. The PHONO / LINE (6)
enables you to se the (18) input to Phono or Line. A GROUND SCREW (21) for you to ground
your turntables is located on the rear panel. The Stereo CD (19) inputs will accept any line
level input such as a CD player.
5. Headphones can be plugged into the front panel mounted HEADPHONE (14) Jack.
Operation
1. POWER ON: Once you have made all the equipment connections to your mixer, press the
POWER (12) button. The power will turn on and the POWER LED (22) will glow RED.
2. CHANNEL A: Switch (4) allows you to select the PHON 1/ LINE 1 (17) jack to input phono or
line level. The CHANNEL SLIDE (5) controls the input level of this channel.
3. CHANNEL B: Switch (6) allows you to select the PHONO 2/ LINE 2 (19) jack to input phono or
line level. The CHANNEL SLIDE (7) controls the input level of this channel.
4. CHANNEL C: The CHANNEL SLIDE (9) controls the input level of this channel.
5. CROSSFADER: The CROSSFADER (10) allows you to the mixing A/B source into another.
6. TALKOVER (3): The purpose of the talkover section is to allow the program playing to be
muted so that the mic can be heard above the music. When you press the button, the
talkover will be on and the volume of all sources except the Mic inputs are lowered by 14dB.
7. The CUE button (1) allows you to select the source among MIC, Channel A, Channel B or
Channel C that you want to monitor in the headphones.
8. The STEREO MONO (8) switch allows you to make the overall output mono.
9. DISPLAY: The DISPLAY (13) indicates either the MASTER output left and right levels.
Specifications
MIC L & MIC R sensitivity............................................................................ 8mV (600 Ohms)
PHONO sensitivity .............................................................................................. 5mV (47kΩ)
LINE/CD sensitivity ......................................................................................... 350mV (22kΩ)
Master output .............................................................................. typical 775mV, max. 1.5V
Frequency response ...................................................................... 20Hz – 20kHz 2dB (RIAA)
Talkover attenuation ..................................................................................................... 14dB
Headphone output ........................................................................................ 200mV/8/16 Ω
Electric products must not be put into household waste. Please bring them to a recycling centre.
Ask your local authorities or your dealer about the way to proceed.
©Copyright 2013 LOTRONIC Av. Zénobe Gramme 11 – B – 1480 SAINTES
3
Publicité
