EUROM SF 2007C Manuel D'instructions Et D'entretien page 9

IMPORTANT SAFETY FEATURE
This heater is provided with an over-temperature control that will turn the heater
automatically off if overheating occurs. The unit can in principle resume power after
caused objects or conditions (such as covering by a towel or the heat outlet too close
to a wall), are removed.
In case of overheating, unplug the heater immediately and let it cool down. Make sure
that it is not damaged and correct the reason for the overheating before starting it
again. Do not continue to operate the heater when this safety device repeats to turn
the heater of. Make always sure that the heater is on a level surface, and that the
outlet is obstructed by dust or dirt.
MAINTENANCE AND CLEANING
1) Before cleaning, turn off the heater, unplug the powercord and allow the heater
to cool down.
2) Do not immerse cord, plug or heater in water or other liquid or pour water or
other liquid over the heater.
3) Use a vacuumcleaner to remove dust and lint from air openings.
4) To clean the exterior painted surfaces use a solution of water and an mild
detergent, with wrungout damp (not wet!) sponge. Wipe the heater finally with a
dry cloth. Allow sufficient time to dry before plugging the electric cord into the
outlet again.
DO NOT USE THE HEATER IF IT HAS MALFUNCTIONED OR BECOME
DAMAGED IN ANY WAY. CONTACT AN AUTHORIZED SERVICE REPRESENTIVE
FOR INFORMATION AND ASSISTANCE.
CAUTION:
THIS HEATER ONLY OPERATES IN UPRIGHT POSITION.
-
STORE THE HEATER IN COOL DRY LOCATION, WHEN NOT IN USE.
-
DO NOT STORE UNTIL THE HEATER HAS COOLED DOWN
-
WARNING:
ANY OTHER SERVICING SHOULD BE PERFORMED BY AN AUTHORIZED
-
SERVICE REPRESENTIVE.
THE HEATER MUST NOT BE LOCATED IMMEDIATELY BELOW A SOCKET
-
OUTLET.
DO NOT USE THIS HEATER IN THE IMMEDIATE SURROUNDINGS OF A
-
BATH, A SHOWER, OR A SWIMMING POOL.