Publicité
Les langues disponibles
Les langues disponibles
IMPORTANT SAFEGUARDS
1)
Read all instructions before using this heater.
2)
This heater is hot when in use. To avoid burns, do not let bare skin touch hot
surfaces. Use the handle when moving the heater. Keep combustible materials,
such as drapery and furnishings at least 3 feet (0,9m.) from the front of the
heater and away from the side and rear.
3)
Extreme caution is necessary when any heater is used by or near children or
invalids and whenever the heater is left operating and unattended.
4)
Always unplug the heater when not in use.
5)
Do not operate any heater with a damaged cord or plug or after the heater
malfunctions, has been dropped or damaged in any manner. Return heater to an
authorised service facility for examination, electrical or mechanical adjustment,
or repair.
6)
Do not use this heater outdoors.
7)
This heater is not intended for use in bathrooms, laundry areas and similar
indoor locations. Never locate the heater on a place where it may fall into a
bathtub or other water container.
8)
Do not run cord under carpeting. Do not cover cord with throw rugs, runners or
the like. Arrange cord away from traffic area and where it will not be tripped
over.
9)
To disconnect heater, turn at first the switch to 'off' and then remove the plug
from the outlet.
10)
Connect to properly grounded outlets only.
11)
Do not insert or allow foreign objects to enter any ventilation or exhaust
opening as this may cause an electric shock or fire, or damage the heater.
12)
To prevent a possible fire, do not block air intakes or exhausts in any manner.
Do not use on soft surfaces, like a bed, where openings may become blocked.
13)
A heater has hot and arcing or sparking parts inside. Do not use it in areas
where gasoline, paint or other flammable liquids are used or stored.
14)
Use this heater only as described in this manual. Any other use, not
recommended by the manufacturer, may cause fire, electric shock, or injury to
persons.
15)
Avoid the use of an extension cord because the extension cord may overheat
and cause a risk of fire. However, if this heater is used with an extension cord,
the conduction wire inside the cord should be at least 1 mm. in diameter and the
current rated not less than 10 Amp.
16)
SAVE THESE INSTRUCTIONS
Publicité
