Rittal CMC III Notice D'installation Et Notice D'utilisation Succincte page 10

Installation and operation, Service
5.3 Settings
Via the CMC III PU website, it is possible, in particular, to configure when the door control module
EN
should open the connected doors in case of an alarm. The following options are available for this pur-
pose:
– Temperature limit on external temperature sensor exceeded
– External signal on digital signal input
Caution!
Once configuration is complete, all settings must be tested, e.g. via manual ac-
tivation of an alarm. Only in this way is it possible to ensure that the connected
doors will actually open as required in the event of an alarm.
For any required software updates, please visit www.rittal.com or contact Rittal Service (see section 6)
6 Service
For technical queries, please contact:
Tel.: +49(0)2772 505-9052
E-mail: info@rittal.com
Homepage: www.rittal.com
For complaints or service requests, please contact:
Tel.: +49(0)2772 505-1855
E-mail: service@rittal.com
10 Rittal CMC III Door Control Module