Assembly - CERTIFIED 060-0181-8 Guide D'utilisation

MAINTAINANCE

ASSEMBLY

BEFORE EACH USE
WARNING
Always ensure that the lawn mower is switched off and the plug is removed from the
1. Inspect the jigsaw, the trigger switch, the cord and the accessories for damage.
power source before making any adjustments or performing maintenance tasks.
2. Check for damaged, missing, or worn parts.
3. Check for loose screws, misalignment or binding of moving parts, or any other condition
WARNING
that may affect the operation.
Read and follow the assembly and adjustment instructions for your lawn mower. All
fasteners are in the parts bag. Do not discard any parts or material until the unit is
4. If abnormal vibration or noise occurs, turn off the tool immediately and have the
problem corrected before further use. Unplug the tool from power source before cleaning assembled.
or performing any maintenance. Using compressed air may be the most effective
cleaning method. Always wear safety goggles when cleaning tools using compressed air.
When assembling the lawn mower, refer to the
illustration on the front cover and the ones here
(Figs. 4 and 5) to aid in the assembly.
1. Fit the upper handle, middle handle and lower
handle together with the quick release lock
system. You can rotate the quick release lock
to adjust its tightness. (Fig. 4)
2. Hang the collection bag as shown. (Fig. 5)
Tidy the connection cord WARNING!
• Do not allow brake fluids, gasoline and petroleum-based products, penetrating oil, etc. come into
As shown in Fig. 6.
contact with plastic parts. These substances contain chemicals that can damage, weaken, or
destroy plastic.
Attach the connection cord to the handle with the
• When servicing, use only identical replacement parts. The use of any other parts may create a
hazard or cause damage to the product.
cord clip (supplied).
• Use only accessories that are recommended for this jigsaw by the manufacturer. Accessories that
may be suitable for one tool may become hazardous when used with another tool.
• Maintain tools with care. Keep cutting tools sharp and clean. Properly maintained tools with sharp
cutting edges are less likely to bind, and are easier to control.
• To ensure safety and reliability, all repairs should be performed by a qualified service technician.
• If the replacement of the supply cord is necessary, this has to be done by the manufacturer or his
agent in order to avoid a safety hazard.
Fig. 4
Fig. 5
Fig. 6
clip
15 13