CERTIFIED 060-0181-8 Guide D'utilisation page 10

ADJUSTING THE BASE PLATE FOR BEVEL
To reduce the likelihood of disconnection of the lawn mower cord from the extension cord during
operating, use one of the plug-receptacle retaining straps or connectors described in this
CUTTING (Fig. 2)
manual.
1. Use the hex key to loosen the two hex
screws located on the underside of the tool.
9) Handle cord carefully – Never pull lawn mower by cord or yank on the cord to disconnect it
2. Move the base plate back slightly and tilt it
from the receptacle. Keep cord from heat, oil, and sharp edges.
to the desired angle, between 0 and 45° left
10) Don't force lawn mower – It will do the job better and safer at the rate for which it was designed.
or right, referring to the scale marked on the
11) Don't overreach – Keep proper footing and balance at all times.
base bracket.
12) Stay alert – Watch what you are doing. Use common sense. Do not operate lawn mower when
3. Move the plate or guide roller forward until you are tired.
the back of the blade rests in the groove of the guide roller.
13) Disconnect lawn mower – Disconnect the lawn mower from the power supply when not in use,
before servicing and when changing accessories such as blades, and the like.
4. Securely tighten the hex screws.
14) Store idle lawn mower indoors – When not in use, lawn mower should be stored in an indoor,
Accurate work requires a trial cut. Measure the work after cutting and reset the angle
dry and locked-up place – out of reach of children.
setting until the correct setting is achieved.
15) Maintain lawn mower with care – Keep cutting edges sharp and clean for best and safest
performance. Follow instructions for lubricating and changing accessories. Inspect lawn
DUST EXTRACTION (Fig. 3)
mower cord periodically and if damaged, have it repaired by an authorized service facility.
1. Insert the vacuum adaptor tube onto the
Inspect extension cords periodically and replace if damaged. Keep handles dry, clean, and
groove in the dust port.
free from oil and grease.
2. Rotate the vacuum adaptor tube until the
16) Keep guards in place and in working order.
tube is secured on the tool.
17) Keep blades sharp.
18) Keep hands and feet away from cutting area.
19) Objects struck by the lawn mower blade can cause severe injuries to persons. The lawn
should always be carefully examined and cleared of all objects prior to each mowing.
20) If lawn mower strikes a foreign object, follow these steps:
i) Stop lawn mower. Release the switch.
ii) Unplug power cord.
iii) Inspect for damage.
iv) Repair any damage before restarting and operating the lawn mower.
21) Use identical replacement blades only.
IMPORTANT SAFETY INSTRUCTIONS FOR WALK-BEHIND MOWERS
I. GENERAL OPERATION
1. Read, understand, and follow all instructions on the machine and in the instructions before
starting the lawn mower.
2. Do not put hands or feet near or under the machine. Keep clear of the discharge opening at
all times.
WARNING!
3. Only allow responsible adults who are familiar with these instructions to operate this
• Always unplug the saw from the power source before making any adjustments or attaching
machine.
accessories.
• Do not use a dust extraction system or a vacuum cleaner when cutting metal. Sparks may ignite
residual wood dust.
Fig. 2
Plate
Fig. 3
Guide Roller
9 9