Outside Air Connection - Jøtul F 305 R B Manuel D'installation Et D'utilisation

Fig. 10
8. Adjust the base with the height adjustment screws using
the hex key placed in the bag of screws. NB! Take into
account the height of the fl oor plate.
9. Mark on the wall if there has to be a rear outlet for fl ue pipe
and external air supply (see fi g. 1). If there has to be a
rear outlet for fl ue pipe and/or external air supply, move the
oven from the wall and prepare the connections.
Approval label
Jøtul F 305 with base
Fig. 11
B
1. Take the approval label (A) out of the ash pan and fasten
it with the nut (B), as displayed. The nut needs to be
tightened only with the fi ngers. NB: Do not cut off the
wire used for fastening the label.

4.3 Outside air connection

If external air supply is not used
Fig. 12
2. If external air supply is not used, the external air connector
(A) can be unscrewed, if desired. Remove the four screws
used for fastening the external air connector and then the
connector itself. (For products with base: If necessary,
you can unscrew the heat shield beneath the burn chamber
in order to facilitate the dismantling of the external air
connector.
3. Install the convection plate back in its place after removing
the external air connector.
A
ENGLISH
A
21