I - Initial Verification; Unpacking The Harmonys; Cleaning; Pre-Requisit - Bodet Harmonys Trio Notice D'utilisation Et D'installation

I - Initial verification

Thank you for choosing a BODET Harmonys Trio. This product has been carefully designed for
your satisfaction based on ISO9001 quality requirements.
We recommend that you read this manual thoroughly before attempting to manipulate the
product.
Keep this booklet during all the life of your product, so that you can refer to it each time it is
necessary.
Bodet cannot be held responsible for damages caused to the product due
to use that does not conform to the instructions described in this manual.
Any unauthorised modification of the product will invalidate the warranty.
1.1 Unpacking the Harmonys Trio
Unpack with caution and check the contents.
The wall mounted Harmonys Trio (907715) must contain:
■ Wall sounder,
■ This quick start.

1.2 Cleaning

Use an antistatic product.
Never use alcohol, acetone or other solvents which may damage product casing.

1.3 Pre-requisit

For the commissioning of the Harmonys Trio sounder, you must install the SIGMA software
(version > V1.16xx or above) (supplied on CD with your master clock) on your PC. To download
the latest version of the software, contact our export department who will send you the download
links by email: export@bodet-timesport.com.
To check compatibility of your equipment and the software version, please have the
version of your master clock.
SLockdown alarms and melodies are available for download on the Bodet website at the following
address :
http://www.bodet-time.com/en/bell-systems/download-melodies.html
The Ethernet port to which the Bodet Harmonys Trio is connected must be PoE+, the
power being supplied by a PoE+ switch or a PoE+ injector. Harmonys Trio can function
while being powered by a PoE switch however some of its operations will be limited (refer
to section 3.7). Make sure that the power capacity of your switch or injector is sufficient to
power your product.
Bodet recommends the following brands:
■ PoE+ injectors: Planet PoE-164 (to be used on non PoE Ethernet connections).
■ PoE+ switches: D-Link, Cisco, NetGear.
4