Laerdal HeartStart Trainer Mode D'emploi page 7

HeartStart Trainer Kit Contents
The HeartStart Trainer M5086A comes
with the following:
• Trainer
• Adult training pads cartridge
• Instructions for Use
• External Manikin Adapter strip (1)
• Quick Reference
Optional Accessories
• M5086-91900 HeartStart Trainer
Instructions for Use
• M5073A Adult Training Pads Cartridge
• M5074A Infant/Child Training Pads Cartridge
• M5093A Replacement Adult Training Pads*
• M5094A Replacement Infant/Child Training Pads*
• M5088A Internal Manikin Adapter (1/pouch)
• M5089A External Manikin Adapters (5/box)
Installing or Replacing the Batteries
The HeartStart Trainer is powered by four AA alkaline batteries.
To install or replace the batteries, follow the steps below:
1. Press the latch on the battery compartment door
on the back of the Trainer. Lift off the door and set
it aside.
2. Remove the old batteries and recycle appropriately.
3. Insert four new AA alkaline batteries into the recess,
oriented according to the diagram provided on
the inside of the recess.
4. Replace the battery compartment door and press
down to ensure the latch holds it in place.
* Includes pads and replaceable film seal.
NOTE: Do not mix battery brands. Do not mix old and new batteries. Replace all
batteries at the same time.
If the Trainer is not to be used for some time, remove batteries to prevent possible
leakage and corrosion.
Using the Manikin Adapters
The training pads should be used on a CPR training manikin equipped with a
disposable External Manikin Adapter M5089A (A) or an Internal Manikin
Adapter M5088A (B), to simulate the patient.
The adapters must be purchased separately.
6