Shutting Down; Emptying And Cleaning - Gloria pro8 Mode D'emploi

RZ_pro 8_980043-00.qxp_Text_GB_pro 8 16.06.17 14:19 Seite 19
Yellow mark:
You work with optimal spraying pressure.
Red mark:
You exceed the permissible operating pressure of max. 3 bar, the pressure gauge with
integrated safety valve blows the overpressure.
NOTE
integrated safety valve "K" trips. Stop pressurising! Lock the pump handle "A" by pushing the
pump all the way down and slowly turning the pump handle "A" clockwise until it stops. Now, turn
the slight resistance until the pump is locked.
6.3 Spraying >>
CAUTION
device and the spraying agents. You must therefore always comply with the safety instruc-
tions/safety measures in this user manual, as well as the following instructions:
 The device must only be operated when suspended in a vertical or steep upright position.
 Pressing the actuation lever down on the quick closure valve initiates the spraying process. This
can be interrupted immediately by releasing the actuation lever.
 Pump when the spray pressure decreases or the yellow marking on the piston gauge is no longer
visible.
 Ensure uniform wetting of the objects when spraying.
7

Shutting down

7.1 Emptying and cleaning >>
Solvents
Gasoline
Oil
tion to the safety instructions in this manual. Observe applicable laws and the specifications
of the agent manufacturers when disposing of residual quantities.
 First vent the tank completely by pulling on the piston gauge with integrated safety valve "K",
and let the air escape completely. The piston pressure gauge with integrated safety valve "K"
must be operated only when the unit is not running.
 The pump is carefully loosened, first by just a few thread turns to the left to ensure that any com-
pressed air left in the tank can escape.
 Then unscrew the pump completely and remove it from the tank.
 When a telescope extension is used, shorten it above the tank in such a way that the remaining
liquid can drip into the tank.
 DO NOT pour the remaining quantity into the spout, but pour it into a suitable canister through
the filling opening. (Observe the manufacturer specifications!).
>>
Figure 12
If the max. operating pressure is exceeded, the piston gauge with
–
Figures
13 14
You may be exposed to hazards that could injure you when handling the
figures
CAUTION
Danger to health due to escaping spraying agents! Pay atten-
–
15 19
19