Renkforce FL-01RG Mode D'emploi page 32

11. Operation
Always pull the mains plug before filling the fog machine.
Never fill the fog machine with flammable liquids or add such to the fog liquid. Only ever use
suitable water-based fog liquids (the CONRAD range features suitable fog liquids, see „Techni-
cal Data").
Never tilt the fog machine. Fog liquid may leak out or enter the inside of the device and cause
damage there or injure the operator.
Make sure that no liquid enters the inside of the device when you are filling it with fog liquid.
This may cause damage to the device and potentially fatal electrical shock.
Fog machine
• Ensure that the mains plug of the fog machine is not plugged in.
• Unscrew the tank cover and fill fog liquid into the tank.
• Then screw on the tank closure lid again.
• Plug the mains plug of the fog machine into a mains socket with a protective ground contact.
• The fog machine now heats up. Heating up takes approx. 5-6 minutes.
• Once the device has reached its operating temperature, the red indicator LED on the radio receiver of the
remote control is lit and the device is ready for operation.
• To activate the fog emission, push the button ON on the remote control of the fog machine.
• To activate the fog emission, push the button OFF on the remote control of the fog machine.
Ensure that the tank never runs empty during fog operation. Should this happen nevertheless,
turn the fog machine off immediately and let it cool down.
Refill the tank after cooling. The fill level is evident at the fill level display (7).
If no fog emerges, the device is still warming up or reheating (the red LED at the remote control
receiver is not lit).
Slight fog lag after deactivation/disconnection of a device is normal and does not suggest a
defect.
If you no longer require the fog machine, disconnect the mains plug and let the device cool
down.
Then empty the tank if the device is not used for any extended period. This prevents leaking of fog
liquid during transport or storage.
32