Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Contents
EC Declaration of Conformity
EC Declaration of Conformity
No. (S-No.): 10404
according to EC directive 2006/42/EC
We,
ATIKA GmbH
Schinkelstraße 97 - 59227 Ahlen - Germany
herewith declare under our sole responsibility that the product
Abricht- und Dickenhobel (Surface planing and
thicknessing) machine type / model ADH 204
Serial number: 004000 - 020000
is conform with the above mentioned EC directive as well as with
the provisions of the guidelines below:
2004/108/EC and 2011/65/EC.
Following harmonized standards have been applied:
EN 61029-1/A11:2010; EN 61029-2-3:2011; EN 55014-1/A1:2009;
EN 55014-2/A2:2008; EN 61000-3-2/A2:2008; EN 61000-3-11:2000
EC type examination carried out by:
TÜV SÜD Product Service GmbH
Certificate-no.: M6A 12 01 41469 612
Keeping of technical documents at:
ATIKA GmbH - Technical department
Schinkelstr. 97 - 59227 Ahlen - Germany
i.A.
Ahlen, 03.07.2013
i.A. G. Koppenstein,
Engineering design management
Extent of delivery
• Surface planing and thicknessing machine ADH 204
• Shavings exhaustor hood
• Shavings exhaustor connector
• 1 pushing block
• 1 pushing bar
• Blade shaft guard
16
• Guide plate
16
• Crank handle for height adjustment
16
• Cutting blade setting gauge
16
• 4 rubber feet
17
• Installation tools
17
• Fasteners
17
• Operating manual
19
19
After unpacking, check the contents of the box
20
22
That it is complete
22
Check for possible transport damage
23
Report any damage or missing items to your dealer, supplier or
23
the manufacturer immediately. Complaints made at a later date
23
will not be acknowledged.
24
25
26
Characteristics noise values
EN ISO 3744
Machine used as surface planer and thicknesser with standard
cutting blades.
Noise power level
L
= 105,9 dB(A)
WA
The factor of measurement uncertainty is 3 dB.
The values g iven are emission va lues and must therefore not
simultaneously represent safe workplace values too. Although there is
a relationship between emission and immersion levels, it can be
reliably deduced whether additional
necessary or n ot. Factors, which can influence the immersio n level
currently existing at the workplace includ e the duration of the effects,
the special type of the wo rkroom, other noise sources, etc. e.g. the
number of machines and other adjac ent processes. The permi ssible
workplace values can also vary
information should however enable an improved assessment
danger and risk to be carried out.
Symbols machine
Carefully read
operator's
manual and the
safety instructions before
starting the machine and
observe the instructions when
operating.
Risk of finger and
hand injury by
the cutting blade.
Wear eye and ear
protection
16
Sound pressure level at the workplace
L
= 92,9 dB(A)
pA
precautionary measures are
from country to country. This
Shut off engine
and remove power
cord before
performing
cleaning,
maintenance or
repair work.
Do not expose to
rain. Protect
against humidity.
Wear dust mask.
Wear protective
gloves.
of the
Publicité
Chapitres
Table des Matières
