Possible Faults - ATIKA ADH 204 Notice Originale

Possible faults

Before each fault clearance
− Switch off device
− Wait unitl the machine comes to a stop
− Pull out power plug
After each fault clearance, put into operation and recheck all security installations.
Fault
Machine fails to start after
switching on or switches off during
idle running
Machine is stalled
machining.
Workpiece is jammed during
thicknessing.
Surface unsatisfactory.
Machined surface too rough.
Machined surface is shaky.
Chip exit blocked
Workpiece advance is slow during
thicknessing.
Possible cause
• Power failure
• Extension cable defect
• Motor or switch defect
• Carbon brushes worn.
during
• Dull cutting blades
• Rate of feed too high
• Motor protecting switch has tripped
• Excessive depth of cut
• Dull cutting blades
• Cutting blades blocked by shavings
• Erratic feeding
• Too much moisture in the workpiece
• Workpiece was machined against the growth
direction
• Too much material cut in a single pass
• keine Absaugung angeschlossen
• Too much moisture in the wood
• Resin on the thicknessing table plate
• Sluggish transport rollers
• Loose belt
Remedy
• Check the fuse.
• Check cable, no longer use defect cable
• Have motor or switc h checked by an
approved electrician or replaced by ori ginal
spare parts
• To correct the pr
manufacturer or costumer service.
• Replace or sharpen the blades.
• Continue working with slower rate of feed.
Switch motor back on after cooling "Motor
protection", p. 20
• Reduce depth of cut and machine workpiece
in multiple passes.
• Replace or sharpen the blades.
• Remove shavings.
• Feed the w orkpiece with c onstant pressure
and reduced speed.
• Dry the workpiece.
• Machine the workpiece in opposite direction.
• Machine the workpiece in multiple passes.
• Stop the machine, remove shavings and
connect the extractor.
• Use dry wood.
• Clean the table plate and apply a thin film of
sliding wax.
• Repair the transport rollers.
25
oblem, refer to the