Working Instructins - ATIKA ADH 204 Notice Originale

Press the green button ( I ) on the switch.
If there is a power cut, the m achine switches off
automatically. Push the green ( I ) butto n to start th e
machine again.
Switching off
Press the red button on the hinged cover.
Motor protection
The motor is equipped with a safety switch and switches
off automatically when overloaded.
It can be switched back on following a cooling off phase
(5 – 10 min).
Press the
1. red button ( 0 ).
2. the small button next to the button (8)
3. the green button ( I ) to start
Dust / chip exhaustion
The wood dust generated during operation impedes the
necessary view and is harmful to health to some degree.
Connect therefore always a chip ex haust system or small
vacuum cleaner with suitable adapter to the chip exhaust neck
(31) (Ø 100 mm).
Make sure that the shavings extractor is properly earthed.
Velocity of air on the extractor connector on the machine
≥ 20 m/sec.
The motor will only st art if the extractor hood (29) is
properly attached and thus releases the safety switch.
Working instructions
Before starting to work consider the following safety
advices to keep the risk of injuries as small as
possible.
Workplace tidied?
Is the s urface planing and thicknessing machine securely
installed?
Are all fastening screws tightened?
Is the blade securely fastened on the blade shaft?
Are the pushing bars handy?
You may not start to operate the machine until you have
read these operating instructions, observed all the
instructions given and installed the machine as described!
Also, note the following important points:
When machining make sure that the unused blade shaft is
covered by the knife guard.
Place yourself outside of the area of danger.
Place your hands flat on the workpiece with fingers closed.
Never remove loose splinters, chips, or similar by hand.
Connect a dust or shavings extractor.
Make sure that the f eed rollers and cutting tools are free
from wood shavings and dust.
Do only machine workpieces the dimensions of which are
within the specifications for this machine (see "Technical
data" on page 26).
Do not guide back t he workpiece over the open-running
blade shaft.
Adjust the smallest cutting depth after your work is finished.
Ensure that you always comply with t he safety
instructions given on p. 17
Surface planing
The objective of surface planing is to smooth a rough surface
(planing), e.g. to smooth the edge of a board.
For this the workpiece is placed onto the feed table plate and is
machined on its underside. Feed direction is from right to left.
Preparations
Pull the mains plug before performing
settings.
Installing the dust extractor
1. Place the crank handle (15) onto the shaft end on the table
plate and turn it a nticlockwisely to bring the thicknessing
table plate to its lowest position.
2. Place the extractor hood (29) onto the thicknessing table
plate. Make sure that the both stop pins engage in the holes
of the thicknessing table plate.
3. Turn the crank handle (15) clockwisely until the extractor
hood (29) is securely clamped by the thicknessing table
plate.
4. Fix the extractor hood using the nut M6 and a washer A 6.4.
H
5. Remove the crank handle (15).
6. Push the extractor connector (31) on the extractor hood.
7. Connect the shavings extractor with the extractor connector
(31).
Planing and joining workpieces
Adjusting the guide plate (1)
1. Loosen the locking lever (21).
If you can not sufficiently turn the locking lever, pull out the
lever head and turn it back.
2. Tilt the guide plate to your desired angle which you can read
from the angle scale (22).
3. Tighten the locking lever (21) again.
20
F
G
I - J
L