Maintenance And Care; Transport - ATIKA ADH 204 Notice Originale

Maintenance and Care

Before each maintenance and cleaning work
− Switch off device
− Wait unitl the machine comes to a stop
− Pull out power plug
Maintenance and repair work other than those described in this
chapter is only allowed to be carried out by service staff.
For maintaining and cleaning, removed security devices must
unconditionally be mounted properly and proved again.
Use only original parts. Oth er parts can result in u nexpected
damages and injuries.
Cleaning
Observe the following to maintain the operability of the
machine:
Do not wash down device with water.
Remove splints and dust only with a brush or vacuum
cleaner.
Slightly spray maintenance spray or dry-film lubricant on the
height adjustment device (5) of the thicknessing table.
Take care that th e feed rollers remain free of rust and
resin.
Remove resin residues from the table plate surfaces.
Resin residues can be removed with a com mercial
maintenance and care spray.
Apply a thin film of sliding wax on the feed, delivery and
thicknessing table plates.
Regularly remove resin from the bl ade shaft and from t he
parts attached to it. For this pur pose put the clam ping
device, the blade holders and the blades into paraffin,
gasoline or commercial resin remover for 24 hours.
Maintenance
The cutting blades are wearing parts and will become dull after
longer or frequent use.
If so, replace the cutting blades or have them sharpened.
Regrinding of cutting blades is only allowed to a height of
15 mm.
Always use cutting blades which are approved for the machine
(see "Technical data").
Replace or sharpen both cutting blades together.
Before replacing or sharpening the cutting
blades unplug the machine.
Danger of cut ting! Wear gloves when replacing the
cutting blades.
Replacing the cutting blades
1. Remove the guide plate (1).
2. Fully push off the blade shaft guard (12) from the table plate.
3. Loosen the nuts of the clamping screws (A) u sing the
supplied open-end spanner.
If the nuts are not visible, carefully turn the blade shaft (34)
using a waste wood block.
4. Remove the clamping device (36) and the blade (35).
5. Clean all parts including the blade slots in the blade shaft.
6. Re-insert the clamping device with a n ew or sh arpened
blade.
7. Align the blade:
- Place the setting gauge (32) for the cutting blades onto
the delivery table plate.
- Firmly press the gauge onto the delivery table plate while
making sure that the edge of the setting gauge is flush
with the edge of the delivery table plate.
- Then, the curved surface of the setting gauge presses
the blade in its correct position.
- Retighten the clamping screws.
When doing so start in the centre and move outwards.
8. Replace also the other blade of the blade shaft.
9. Push the blade shaft guard over the blade shaft.
Maintenance of the gearbox
1. Remove the cap nuts and the both recessed head screws
from the gearbox cover.
2. Remove the gearbox cover (10).
3. Remove wood dust and shavings using the shavings
extractor or a brush.
4. Slightly spray maintenance spray on the roller chain (38)
and on the bearings of the belt roller and pulley.
Do not use grease.
5. Re-mount the gearbox cover.

Transport

Remove mains plug before each transport.
Before any transport make sure that the blade shaft guard
fully covers the blade shaft.
This will avoid injury by the blades.
When handling do not take hold on the feed or delivery
table. Take hold on the bottom of the machine.
22
T
V
W
X
U