Honda HSS622 Manuel De L'utilisateur page 40

Skid
Adjust the skid for the auger housing ground clearance best suited to
your snow removal conditions.
To prevent accidental starting, turn the engine switch to the OFF
position and disconnect the spark plug cap.
1. Place the snowblower on a level surface and set the height adjusting
bolts in the middle position.
2. Loosen the bolts and adjust the skid and scraper height according to
the road surface condition.
AUGER
For use on uneven surfaces, lower the skid up to the bottom to obtain
the maximum scraper ground clearance.
Factory pre-set clearance:
At the scraper:
At the auger:
Adjust the skid equally on both sides.
Be sure to tighten the skid and scraper bolts securely after making
adjustment.
Do not use the snowblower on rough or uneven surfaces with the
auger ground clearance set for hard snow or surfaces.
This may cause serious damage to the snow blowing mechanism.
−
3.0 7.0 mm (0.12 0.28 in)
−
8.0 12.0 mm (0.31 0.47 in)
(Track type only)
BOLTS
SCRAPER
SKID
−
−
37