Calibration - Ecolab MULTRONIC Manuel Technique

4.4

Calibration

In order to calibrate the ClO
electrode is functional and that circulation around the electrode is appropriate.
The main menu for adjusting the Multronic can be accessed through operating the ↑-key
in the measuring mask.
Main menu
The calibration function is selected through placing the cursor onto the selected item and
operating the ENTER key.
Calibration module
selection
(not available at
Multronic OC!)
The ClO -measuring module that is to be calibrated can now be selected. To do so,
2
move the cursor onto the corresponding selected item and operate the ENTER key.
Calibration ClO
The go on function is used to terminate the calibration of the ClO
and opens the calibration module selection menu.
The calibration start function starts the calibration of the ClO
following information is then displayed on the screen.
Rinse with sampling
water
417101816_Anhang09_ClO2.doc
-measurement it is necessary to ensure that the measuring
2
2
ClO Measuring Module
2
- 35 -
-measuring module
2
-measuring module. The
2
Rev.: 05-07/10