Start Up; Configuration - Ecolab MULTRONIC Manuel Technique

4

Start up

4.1

Configuration

The main menu for adjusting the Multronic can be accessed through operating the ↑-key
in the measuring mask.
Main menu
Select configuration through placing the cursor onto the selected function and operate
the ENTER key.
Configuration menu
Select module configuration through placing the cursor onto the selected item and
operate the ENTER key.
Configuration
module selection
(not available at
Multronic OC!)
The ClO -measuring module that is to be configured can now be selected. To do so,
2
move the cursor onto the corresponding selected item and operate the ENTER key.
The adjustment of the ClO
ClO -configuration
2
page 1
The type of controller can be selected with the control device function.
Value range: Signalling device / 2-pt. PID / 2-pt. fuzzy / 2-pt. aFUZa / 2-pt. aFUZs / 3-pt.
PID / 3-pt. fuzzy / 3-pt. aFUZa / 3-pt. aFUZs
The settings aFUZa and aFUZs relate to adaptive fuzzy controllers that independently
adapt themselves to the control process. aFUZa is an asymptotic fuzzy controller without
overshoots. aFUZs attains the nominal value with a quick algorithm while accepting
overshoots.
417101816_Anhang09_ClO2.doc
ClO Measuring Module
2
-measuring module configuration is carried out on two pages.
2
- 26 - Rev.: 05-07/10