Publicité
Les langues disponibles
Les langues disponibles
6. FUNCTIONING / MANIPULATION
a) Installation / assembly:
- Unpack carefully the device of its packaging.
- Place it on a plane and heatproof surface.
- Never place the device near a wall or near a partition makes of combustible materi-
als even if it is very well isolated.
- A distance of minimum 10 cm with the partition or the wall is necessary.
- Remove the labels and protective film around the device. If needed you can use a
solvent
b) First starting:
First cleaning
Before the 1st use, clean the machine (See 7.Cleaning and maintenance)
During the 1st use, warm up your oven during 30 min at 250°C. It can emit some
smoke for a while.
Connection of the device
- Check that the tension and the frequency of the electricity network suit to the values
indicated on the descriptive plate.
- Check that neither the cord nor the plug are damaged. If necessary, it has to be
replaced by the manufacturer, its after sale service or any qualified person to avoid
any risk.
- Make sure that every control knob is positioned on 0.
- Unwind completely the electric power cable and connect it in a plug connected with
the earth.
- The device is connected.
NB: in case of connection of the device in a plug without earth protection or directly
on the electricity network, confide its connection to a qualified person .
How to connect the equipotential link.
Your oven is fitted with air humidifier. It is connected to the main water supply and
had to be connected to the equipotential link of your own supply. The screw for this
purpose is placed on the rear of the oven, next to the cord.
24
Publicité
