Disposal; Replacement Parts And Wearing Parts; Warranty/Service - EMS Emser Mode D'emploi

ance with IEC61000-3-2, IEC61000-3-3, IEC61000-4-2,
IEC61000-4-3, IEC61000-4-4,
IEC61000-4-6, IEC61000-4-11) and EN13544-1 and are
subject to particular precautions with regard to electro-
magnetic compatibility. This device meets the require-
ments of European Directive 93/42/EEC for medical devic-
es, as well as those of the Medizinproduktegesetz (German
Medical Devices Act).
Notes on electromagnetic compatibility
• The device is suitable for use in all environments listed
in these instructions for use, including domestic envi-
ronments.
• The use of the device may be limited in the presence
of electromagnetic disturbances. This could result in
issues such as error messages or the failure of the dis-
play/device.
• Avoid using this device directly next to other devices or
stacked on top of other devices, as this could lead to
faulty operation. If, however, it is necessary to use the
device in the manner stated, this device as well as the
other devices must be monitored to ensure they are
working properly.
• The use of accessories other than those specified or
provided by the manufacturer of this device can lead to
an increase in electromagnetic emissions or a decrease
in the device's electromagnetic immunity; this can result
in faulty operation.

12. Disposal

Battery disposal
• Empty, completely flat batteries must be disposed of
through specially designated collection boxes, recycling
points or electronics retailers. You are legally required
to dispose of the batteries.
• The codes below are printed on batteries containing
harmful substances:
Pb = Battery contains lead,
Cd = Battery contains cadmium,
Hg = Battery contains mercury.
General disposal
For environmental reasons, do not dispose of the device in
the household waste at the end of its useful life. Dispose of
the device at a suitable local collection or recycling
point. Dispose of the device in accordance with
EC Directive – WEEE (Waste Electrical and Elec-
tronic Equipment). If you have any questions, please con-
IEC61000-4-5, tact the local authorities responsible for waste disposal.
13. Replacement parts and wearing
Replacement parts and wearing parts are available from
the corresponding listed service address under the stat-
ed material number.
Designation
Mouthpiece (PP), adult mask
(PVC), children's mask (PVC),
mesh atomizer with medica-
tion container (PC)
Mesh atomiser with medica-
tion container (PC)

14. Warranty/service

In case of a claim under the warranty please contact your
local dealer or the local representation which is mentioned
in the list "service international".
In case of returning the unit please add a copy of your re-
ceipt and a short report of the defect.
The following warranty terms shall apply:
1. The warranty period for EMSER products is either 5
years or- if longer- the country specific warranty peri-
od from date of Purchase.
In case of a warranty claim, the date of purchase has
to be proven by means of the sales receipt or invoice.
2. Repairs (complete unit or parts of the unit) do not ex-
tend the warranty period.
3. The warranty shall not be valid for damages because of
a. improper treatment, e.g. nonobservance of the us-
b. repairs or tampering by the customer or unau-
c. transport from the manufacturer to the consumer
d. The warranty shall not be valid for accessories
4. Liability for direct or indirect consequential losses
caused by the unit are excluded even if the damage
to the unit is accepted as a warranty claim.
22
parts
er instructions.
thorised third parties.
or during transport to the service centre.
which are subject to normal wear and tear (cuff,
batteries etc.).
Material REF
PP/PVC/PC 602.11
PC 163.899