Installation Procedure - Fulgor Milano F4DWD24S1 Instructions Pour L'installation Et L'utilisation

EN
Do not under any circumstances cut or remove grounding
prong from the appliance cord.
WARNING
• If cold water pipe is interrupted by plastic, non metallic
gaskets, union connections or other insulating materials,
DO NOT use for grounding.
• DO NOT ground to a gas pipe.
• DO NOT have a fuse in the NEUTRAL or GROUNDING
circuit. A fuse in the NEUTRAL or GROUNDING circuit
could result in an electrical shock.
• Check with a qualified electrician if you are in doubt as to
whether the appliance is properly grounded.
• Failure to follow these instructions could result in serious
injury or death.
CAUTION
Do not repair or replace any part of the appliance
unless specifically recommended in the manual. All other
servicing should be done by a qualified technician. This
may reduce the risk of personal injury and damage to the
appliance.
Never modify or alter the construction of the appliance by
removing panels, wire covers, screws, or any other part
of the product.
10
Grounding prong

Installation procedure

Before you begin assembling the drawers of the appliance,
make sure there is enough room to fit the drawer and the
appliance.
The precise dimensions for the installment are indicated in
inches and mm.
• Turn power off to the electrical outlet.
• Insert plug into three-prong, grounded outlet (see "Power
Requirements and Grounding" for electrical specification).
N
• Position the drawer so that it is directly centered and slide
L
warming drawer assembly into cutout until it is flush with
cabinet.
• Avoid pinching the power cord between the unit and
cabinet wall.
• Open the warming drawer to full extension and fix the
structure to the wall with the two screws provided.
• Turn power back on to the electrical outlet.
• Turn the warming drawer on. Close the drawer for
approximately 1 minute then check for warmth.
INSTALLATION