Appliance Installation - Fulgor Milano LD12 Instructions Pour L'installation Et L'utilisation

7 APPLIANCE INSTALLATION

7.1 Before you begin installation
Open the drawer and remove all accessories and
packing materials.
Attention! The front of the drawer may be covered
with a protective coating over it. Carefully remove
the protection before using the object-holder drawer,
starting to detach it from below. Make sure that the
drawer is not damaged. Be certain that the drawer
closes properly. In case of damage, contact the
Service Department.
The object-holder drawer can only be built-in on
appliances specified by the manufacturer. The
manufacturer does not guarantee the operation of the
appliance if materials from a different manufacturer
have been used. The manufacturer is not responsible
for damage caused by improper use.
7.2 Proceed
Before installing the object-holder drawer and
the appliance combined with it, provide a fixed
intermediate shelf in the cabinet with the capacity to
support both appliances.
The combined appliance is then positioned without
further intermediate shelves directly on the built-in
object-holder drawer.
For the combined, built-in appliance, absolutely follow
the instructions for use and assembly.
The main dimensions for the built-in appliance are
indicated in mm and shown on the installation
diagram. For installation proceed as follows:
1. place the drawer of the cabinet so that it is well
centred and aligned;
2. make sure that the frame perfectly adheres to the
cabinet;
3. open the drawer and fasten the housing to the walls
of the cabinet with the two screws provided.
19
GB