Vulcan TCM Série Notice D'utilisation page 44

3V-490058NU – 12/21
23.4 WATER TREATMENT
This message appears only when the capacity of the water treatment system is being approached (if the counter has been set in Client
parameters). This counter is only used if the unit has two separated water supplies.
WATER TREATMENT COUNTER
- Go into the "TOOL BOX" screen
- Select the "Client parameters" screen
- Enter the password "CHEF" Permanent pass word (Upper or lower case)
- Validate "V": if the code is correct the menu can be accessed if not return to inputting the PIN
- To modify or enter the value for the capacity of the water treatment system (in litres). Set to zero by default (if the oven does not have a
dedicated water treatment system).
* Select the zone to be changed
* Adjust with the coder knob.
- After any regeneration of the water treatment, reset the counter as required.
* Press « RESET »
* Confirm by pressing « YES »
Page 11
Warning message
This message appears every time the oven is switched on if the programmed water
➔
capacity is has reaching its limit.
After renewal of the system reset the counter as above.
➔
The water treatment system's capacity in litres. Reset.
By default set to zero (if there is no dedicated treated water supply to
the oven)
VULCAN
A division of ITW Food Equipment Group LLC
P.O. Box 696
Louisville, KY 40201
EN