Pelgrim GVW5840NY Notice D'utilisation page 34

34
Malfunction
The appliance does not fill with
water.
The appliance does not drain
the water.
The anti-flood device is on.
The start of the washing pro-
gramme does not occur.
After the check, activate the appliance. The
programme continues from the point of in-
terruption.
If the malfunction occurs again, contact the
service centre.
If the display shows other alarm codes,
contact the service centre.
The necessary information for the service
centre is on the rating plate.
The washing results and drying results are not satisfactory
Problem
The dishes are not clean.
Possible cause
The water tap is blocked or
there is limescale on it.
The water pressure is too low.
The water tap is closed.
The filter in the water inlet hose
is blocked.
The connection of the water in-
let hose is not correct.
The water inlet hose is dam-
aged.
There is a blockage in the sink
spigot.
The connection of the water
drain hose is not correct.
The water drain hose is dam-
aged.
The appliance door is open.
The mains plug is not connec-
ted in the mains socket.
The fuse in the fuse box is
damaged.
The delay start is set.
Record this information:
– Model
(MOD.) ....................................................
....
– Product number
(PNC) ..........................................
– Serial number
(S.N.) ..............................................
Possible cause
The washing programme was
not applicable for the type of
load and soil.
You did not put the items cor-
rectly in the baskets, water did
not touch all surfaces.
Possible solution
Clean the water tap.
Contact your local water au-
thority.
Open the water tap.
Clean the filter.
Make sure that the connection
is correct.
Make sure that the water inlet
hose has no damages.
Clean the sink spigot.
Make sure that the connection
is correct.
Make sure that the water drain
hose has no damages.
Close the water tap and con-
tact the service centre.
Close the appliance door.
Connect the mains plug.
Replace the fuse.
• Cancel the delay start.
• When the countdown is
completed, the washing pro-
gramme starts automatically.
Possible solution
Make sure that the washing
programme is applicable for the
type of load and soil.
Put the items correctly in the
baskets.