Multitab Function - Pelgrim GVW5840NY Notice D'utilisation

Use long washing programmes when
you use the detergent tablets. These
cannot fully dissolve with short washing
programmes and can decrease the
washing results.
Use of rinse aid
Rinse aid makes it possible to dry the
dishes without streaks and stains.
The rinse aid dispenser automatically
adds rinse aid during the last rinsing
phase.
Do these steps to fill the rinse aid dispens-
er:
1. Press the release button
5
lid of the rinse aid dispenser.

Multitab function

The multitab function is for combi detergent
tablets.
These tablets contain agents as detergent,
rinse aid and dishwasher salt. Some types
of tablets can contain other agents.
Be sure that these tablets are applicable for
the water hardness in your area (refer to the
instructions on the packaging of the prod-
ucts).
The multitab function deactivates the flow
of rinse aid and salt.
The multitab function deactivates the indi-
cators of salt and rinse aid.
The programme duration can increase if
you use the multitab function.
Activate or deactivate the multitab
function before the start of a washing
programme. You cannot activate or de-
activate the function when a washing
programme operates.
To activate the multitab function
1. Activate the appliance.
2. Make sure that the appliance is in set-
ting mode.
3. Press and hold function buttons (D) and
(E) at the same time until the multitab in-
dicator comes on.
2. Fill the rinse aid dispenser
3. Remove the spilled rinse aid with an
4. Close the rinse aid dispenser. Press the
Adjust the rinse aid dosage
Factory set: position 3.
You can set the rinse aid dosage between
position 1 (lowest dosage) and position 4
(highest dosage).
Turn the rinse aid selector
6
to open the
decrease the dosage.
4. Release function buttons (D) and (E).
The function is activated.
• When you activate the multitab func-
To deactivate the multitab function and
use separately detergent, salt and rinse
aid
1. Activate the appliance.
2. Make sure that the appliance is in set-
ting mode.
3. Press and hold at the same time, func-
tion buttons (D) and (E) until the multitab
indicator goes on.
4. Release function buttons (D) and (E).
The function is deactivated.
5. Fill the salt container and the rinse aid
dispenser.
6. Adjust the water hardness to the highest
level.
7. Start a washing programme without
dishes.
8. When the washing programme is com-
pleted, adjust the water softener to the
water hardness in your area.
9. Adjust the quantity of rinse aid.
aid. The mark 'max' shows the maxi-
mum level.
absorbent cloth to prevent too much
foam during the washing programme.
lid until it locks into position.
tion, it stays on until you deactivate it.
27
3
with rinse
4
to increase or