Titan PR 33 Notice D'instruction page 32

4
Upon completion of the seal deposit the locking
device and tilt the jack, as shown in the photo,
upwards until the steel strap breaks before the
sealing sleeve.
Again, the air supply must not be stopped.
Then, turn off the air feed and separate the
tension jack from the steel strap again by
pressing the lever.
5
Sketch
Course of strap
The following picture shows a correctly carved seal.
Check the seals regular
for crackings on the sleeve and
for neat cutting edges.
PR33/DPZ-L
4
5
H365 EU 24/12
32 / 63