Care And Cleaning; Troubleshooting - Electrolux EHF3120FOK Notice D'utilisation

Masquer les pouces Voir aussi pour EHF3120FOK:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

8
www.electrolux.com

6. CARE AND CLEANING

WARNING!
Refer to Safety chapters.
6.1 General information
• Clean the hob after each use.
• Always use cookware with clean
bottom.
• Scratches or dark stains on the surface
have no effect on how the hob
operates.
• Use a special cleaner applicable for the
surface of the hob.
• Use a special scraper for the glass.
6.2 Cleaning the hob
• Remove immediately: melted plastic,
plastic foil, and food with sugar. If not,

7. TROUBLESHOOTING

WARNING!
Refer to Safety chapters.
7.1 What to do if...
Problem
You cannot activate or op-
erate the hob.
Residual heat indicator
does not come on.
7.2 If you cannot find a
solution...
If you cannot find a solution to the
problem yourself, contact your dealer or
an Authorised Service Centre. Give the
data from the rating plate. Give also three
the dirt can cause damage to the hob.
Put the special scraper on the glass
surface at an acute angle and move
the blade on the surface.
• Remove when the hob is
sufficiently cool: limescale rings,
water rings, fat stains, shiny metallic
discoloration. Clean the hob with a
moist cloth and some detergent. After
cleaning, rub the hob dry with a soft
cloth.
Possible cause
The hob is not connected
to an electrical supply or it
is connected incorrectly.
The fuse is released.
The zone is not hot be-
cause it operated only for a
short time.
digit letter code for the glass ceramic (it is
in the corner of the glass surface). Make
sure, you operated the hob correctly. If
not the servicing by a service technician or
dealer will not be free of charge, also
during the warranty period. The
instructions about the Service Centre and
Remedy
Check if the hob is correctly
connected to the electrical
supply. Refer to the con-
nection diagram.
Make sure that the fuse is
the cause of the malfunc-
tion. If the fuse releases
again and again, contact a
qualified electrician.
If the zone operated suffi-
ciently long to be hot,
speak to an Authorised
Service Centre.

Publicité

Table des Matières
loading

Table des Matières