Vermeiren Inovys II Manuel D'utilisation page 16

EN
NL
1
42
[5]
• (If applicable) demount the headrest (1):
Loosen the star knob (42) of the
o
headrest suppport and remove it.
Pull the headrest up until it is free from
o
the support on the backrest.
34
33
[7]
• Demount the spring from the backrest
frame by opening the brace of the fastener
pin (33) and removing it.
2.4.6 (Dis)Assembling rear wheels (only for 22"/24"):
For transport purposes, it might be necessary to (dis)assemble the rear wheels.
Removing the rear wheels:
1. Press and hold the button (43) while sliding the wheel axle out
of the axle bushy.
2. Repeat this for the other wheel and place the wheelchair gently
on the tipping caps.
Installing the rear wheels:
1. Take one of the rear wheels and lift the wheelchair on one side.
2. Press and hold the button (43) while sliding the wheel axle in
the axle bushy.
3. Release the button to lock the wheel.
[6]
• Loosen the two upper star buttons (36) of
the backrest by hand.
• Pull the backrest upwards until it is
released from the four brackets (35).
34
33
[8]
• Fold the backrest frame (34) down onto
the seat.
• Place the fastener pin (33) back in the
frame.
12
Inovys II
2022-03
Before use
36
35
43